Seagate SCSI Interface Product Manual page 129

SCSI Interface Product Manual, Rev. J
Table 83: Mode Sense page codes supported
Page Code Description
00h Unit Attention page parameters (should be sent last in a group of Mode pages)
01h Error Recovery parameters
02h Disconnect/Reconnect Control parameters
03h Format parameters
04h Rigid Drive Geometry parameters
07h Verify Error Recovery parameters
08h Caching parameters
0Ah Control Mode page
0Ch Notch page
0Dh or 1A Power Condition page
10h Xor Control Mode page
19h SCSI Port Control Mode page
1Ch Informational Exceptions Control page
3Fh Return all supported pages
The detailed information can be obtained by issuing the Mode Sense command requesting changeable values.
Note. There may be implicit associations between parameters defined in the pages and block descriptors.
The block length affects the optimum values (the values that achieve best performance) for the sectors
per track, bytes per physical sector, track skew factor, and cylinder skew factor fields in the format
parameters page. In this case, the drive may change parameters not explicitly sent with the Mode
Select command. A subsequent Mode Sense command would provide information on these changes.
115