Power Supply - SATO CG2 Series Quick Manual

Precautions for Installation and Handling
Printer operation can be affected by the printer environment.
Refer to the following instructions for installation and handling of CG2 Series printer.
Select a Safe Location
Place the printer on a surface that is flat and level.
If the surface is not flat and level, this may result in poor
print quality. This may also cause malfunction and
shorten the life span of the printer.
Do not place the printer on a location that
produces vibration.
Do not carry the printer when the roll label is set.
Giving serious vibration or shock to the printer may
cause malfunction and shorten the life span of the
printer.
Do not place the printer near crane or pressing
machine.
Machinery, such as cranes and pressing machines
requires large amount of power. Being near this
machinery may cause electrical noise or voltage
reduction. Avoid such locations to reduce the risk of
malfunction or damage to the printer.

Power Supply

This printer requires an AC power supply.
Be sure to connect the printer to an AC power supply
via the supplied AC adapter. Failure to do so may result
in malfunction.
Connect the power cord to a grounded power
outlet.
Make sure that the printer is plugged into a grounded
power outlet.
CG2 Series Quick Guide
Keep the printer out of high temperature and hu-
midity.
Avoid locations subject to extreme or rapid changes
in temperature or humidity. Exposure to these
conditions may cause electrical problems within the
printer.
Do not place the printer in a location subject to
water or oil.
Do not place the printer in a location where it will be
splashed with water or oil. Water or oil entering
inside the printer may cause a fire, electric shock, or
malfunction.
Avoid dust.
Dust build up may result in poor print quality. This
may cause not only malfunction but also shorten the
life span of the printer.
Keep out of direct sunlight.
This printer has a built-in optical sensor. Exposure to
direct sunlight will make the sensor less responsive
and may cause the label to be sensed incorrectly.
Close the top cover when printing.
Provide a stable source of electricity to the
printer.
Do not share the power outlets with other appliances
such as a heater and refrigerator requiring a
measurable amount of power. Also, avoid using the
power outlet near where such appliances are
plugged into. This may cause voltage reduction and
malfunction.
Safety Precautions
Page iii