SATO GL408e Programming Reference Manual page 30

Unit 3: Command Quick Reference
COMMAND QUICK REFERENCE
INSTRUCTION
$
$=
Eaaa
EP
EU
EX0
Faaaabcccc ddee
SATO GL4xxe SBPL Programming Reference
Font, Vector. Specifies printing of the unique SATO vector font.
a = A: Helvetica Bold (proportional spacing)
B: Helvetica Bold (fixed spacing)
b = Font width (50 to 999 dots)
c = Font height (50 to 999 dots)
d = Font variation (0 to 9) as follows:
0: Standard
1: Standard open (outlined)
2: Gray (mesh) pattern 1
3: Gray (mesh) pattern 2
4: Gray (mesh) pattern 3
5: Standard, shadow 1
6: Standard, shadow 2
7: Standard mirror image
8: Italic
9: Italic open (outlined)
Outline Font Print. Specifies the print of outline font.
n = Print data
Line Feed. Provides the ability to print multiple lines of the same character
size without specifying a new print position for each line.
aaa = Number of dots (1 to 999) between the bottom of the
characters on one line to the top of the characters on the
next line.
Print End Position. Specifies the label stop position in the sensor valid
mode.
EAN/UCC Composite Symbol. Specifies the composite symbol of EAN/
UCC.
Expanded Print Length. Expands the print length to 9999 dots.
Sequential Numbering. Allows the printing of sequencing fields (text, bar
codes) where all incrementing is done within the printer.
aaaa = Number of times to repeat the same data (0001 to 9999).
b = Plus or minus symbol (+ for increments; - for decrements).
cccc = Value of step for sequence (001 to 9999).
dd = Quantity of digits for sequential numbering (01 to 99).
ee = Quantity of digits free for sequential numbering (01 to 99).
DESCRIPTION
Page 3-10