Table of Contents
Advertisement
Panel Descriptions
Front Panel, Rear Panel
6
No .
Name
LINE IN jack
6
MIC/GUITAR jack
7
PHONES jack
8
USB connector
[INPUT MONITOR] button
9
[Hi-Z] button
[INPUT GAIN] button
(*1): We recommend using one input jack (i.e., either the LINE jack or the MIC/GUITAR jack) at a time.
If devices are connected to both jacks at the same time, the sound input via both jacks is mixed
together, but the DUO-CAPTURE cannot adjust the balance of the mix.
8
7
Description
Used to connect the audio device that will send audio signals to the DUO-
CAPTURE. Use the [INPUT VOLUME] slider to adjust the volume (*1).
Used to connect a guitar or monaural dynamic microphone. Use the [INPUT
VOLUME] slider to adjust the volume (*1).
Used to connect headphones. Use the [OUTPUT VOLUME] slider to adjust the
volume. The stereo miniature phone-type jack on the right can be used as a
LINE OUT jack.
Used to connect the DUO-CAPTURE to a USB cable.
Determines whether the received audio signal is output directly to the
PHONES jack.
LINE IN
MIC/
GUITAR
PHONES
ON:
The input audio signal is output directly.
OFF (AUTO): The input audio signal is not output directly. Note that when
ASIO-compatible software is used, the input audio signal may
be output directly according to the ASIO Direct Monitor setting.
Changes the impedance of the MIC/GUITAR jack (p. 16).
ON:
Select "ON" when a guitar is connected.
OFF:
Select "OFF" when a dynamic microphone is connected.
Changes the input gain of the LINE IN jack and the MIC/GUITAR jack (p. 16).
HI:
Select "Hi" to increase input gain, such as when a dynamic
microphone is connected.
LO:
Select "Lo" when an audio device is connected to the LINE IN jack or
when a guitar is connected.
9
8
+
OFF
ON
+
[INPUT MONITOR] button
AUTO
ASIO-compatible
software
Advertisement
Table of Contents
