Rear Panel - Roland TRI-Capture Owner's Manual

Panel Descriptions
10. [PHONES] knob
Adjusts the volume of the audio signal that is output from the PHONES jack.
* The volume of the signals output from the OUTPUT jacks cannot be adjusted on the TRI-
CAPTURE itself.

Rear Panel

11
11. PHONES jack
Used to connect headphones. The audio signal is output from the PHONES jack regardless of the
[OUTPUT MUTE] button's setting.
12. OUTPUT jack (combined balanced TRS/unbalanced TS)
Outputs the analog audio signal.
* Wiring diagrams for the balanced TRS type jack are
shown in the illustration. Make connections only after
first checking the pin outs of the other equipment you
intend to connect.
An unbalanced TS type jack can also be connected.
13. USB connector
Used to connect to a computer.
Before connecting, you must install the driver (p. 14).
14. INPUT 3 (AUX) jacks
Used to connect an audio device.
Adjust the volume of the audio input signal by using the [INPUT 3 (AUX)] knob.
15. INPUT 2 (GUITAR) jack
Used to connect a guitar or bass.
Adjust the volume of the audio input signal by using the [INPUT 2 (GUITAR)] knob.
12
14
12 13 15 16
HOT (TIP)
HOT (TIP)
GND (SLEEVE)
COLD (RING)
GND (SLEEVE)