Moving Data Of A Specific Note Number To Another Part (Extract Rhy); Setting The Part Parameters (Part Param) - Roland MC-808 Owner's Manual

Moving data of a specific note number
to another part (EXTRACT RHY)
This operation extracts data of a specific note number from the
specified part, and moves it to a different part. You can use this to
divide a rhythm set into separate parts for each instrument.
Parameter Range
Source From Setup,
1–998,
End
Source End Setup,
1–998
Src Part 1–16
Src Note 0 (C-)–127
(G9)
Dest Part 1–16
* If the move-source part does not contain any data of the note number
specified by Extract Note, a message of "Cannot Extract!" will appear.
* If the move-destination part contains no performance data, the setup
parameters (p. 43) of the move-source part will be copied.
* If the move-destination part does contain performance data, only the
note data will be moved. This means that the note data will be played
using the sound of the patch selected for the move-destination part.
Description
first measure of the region to
move data
* If you set this to "SETUP," the
setup parameters (p. 43) will be
included.
last measure of the region to
move data
If you set this to "SETUP," only
the setup parameters will be se-
lected, and no measures will be
included.
Move-source part
Note number to be moved
Move-destination part
Editing patterns (Pattern Edit)
Setting the part parameters
(PART PARAM)
Here you can make settings for each part within the pattern.
You can also use the faders to set the level and pan of each part
(p. 46).
Parameter Range
Level 0–127
(Part Level)
Pan L64–0–63R
(Part Pan)
Key Shift -48–+48
(Part Key
Shift)
Rev Send 0–127
(Part Reverb
Send Level)
Output Assign DRY,
(Part Output MFX1,
Assign) MFX2,
COMP,
DIR,
RHY
Seq Out INT,
(Sequencer EXT,
Output As- BOTH
sign)
Description
Volume of the part
Left/right position of the
part
Transposition of the part
The pitch will change in
semitone steps over a
range of +/-4 octaves.
Reverb level of the part
When the value is "0,"
the original pitch of the
patch itself will be used
without change.
How the original sound of
each part will be output
DRY: Output to MIX OUT-
PUT jacks without passing
through effects
MFX1 (2): Output through
multi-effects 1 (or 2)
COMP: Output through
the compressor
DIR: Output to DIRECT
OUTPUT jacks without
passing through effects
RHY: Output according to
the settings of the rhythm
set assigned to the part
* "RHY" can be set only
when a rhythm set is as-
signed to the part.
Output destination from
the sequencer
INT: Internal sound gener-
ator
EXT: MIDI OUT connector
BOTH: Both of the above
simultaneously
77