Programming In Vfo Mode; Programming In Memory Mode - Icom IC-910H Instruction Manual

n Programming in VFO mode
Memory channel programming can be performed ei-
ther in VFO mode or in memory mode.
q Set the desired operating frequency and mode in
VFO mode.
• Push [V/M 1] to select VFO mode, if required.
• Tone frequency, offset frequency, etc., can also be pro-
grammed.
• Input the frequency from the keypad
Push [F-INP ENT] ⇒ [1] ⇒ [4] ⇒ [4] ⇒ [.] ⇒ [2] ⇒ [6]
⇒ [8] ⇒ [F-INP ENT]
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel to be programmed.
e Push [MW 4] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
To check the programmed contents, push [V/M 1] to
select memory mode.
n Programming in memory
mode
q Push [V/M 1] to select memory mode.
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel to be programmed.
• The tuning dial rotation while pushing [F-INP ENT] also
selects memory channel.
e Set the desired operating frequency and mode in
the memory mode.
• Tone frequency, offset frequency, etc., can also be pro-
grammed.
• Set the desired operating frequency using with the key-
pad when programming into blank channels. The tuning
dial rotation for frequency setting cannot be performed
when a blank channel is selected.
• Input the frequency from the keypad
Push [F-INP ENT] ⇒ [1] ⇒ [4] ⇒ [4] ⇒ [.] ⇒ [1] ⇒ [6]
⇒ [4] ⇒ [F-INP ENT]
r Push [MW 4] for 1 sec. to program the displayed fre-
quency and operating mode into the memory chan-
nel.
MEMORY OPERATION
FM
Set desired frequency
and mode.
USB
Select desired memory
channel.
USB
Beep tones sound.
USB
USB
Select desired memory
channel.
FM
Set desired frequency
and mode.
USB
Beep tones sound.
USB
6
VFO A
VFO A
VFO A
VFO A
MEMO
MEMO
MEMO
MEMO
41