Explicit Definitions; Precautions - Icom IC-910H Instruction Manual

IMPORTANT
READ THIS INSTRUCTION MANUAL CARE-
FULLY
before attempting to operate the transceiver.
SAVE THIS INSTRUCTION MANUAL.
manual contains important safety and operating in-
structions for the IC-910H.

PRECAUTIONS

R WARNING HIGH VOLTAGE! NEVER
tach an antenna or internal antenna connector during
transmission. This may result in an electrical shock or
burn.
R NEVER
apply AC to the [DC13.8V] jack on the
transceiver rear panel. This could cause a fire or ruin
the transceiver.
R NEVER
apply more than 16 V DC, such as a 24
V battery, to the [DC13.8V] jack on the transceiver rear
panel. This could cause a fire or ruin the transceiver.
R NEVER
let metal, wire or other objects touch any
internal part or connectors on the rear panel of the
transceiver. This may result in an electric shock.
R NEVER
expose the transceiver to rain, snow or
any liquids.
AVOID using or placing the transceiver in areas with
temperatures below –10°C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle's
dashboard can exceed 80°C (+176°F), resulting in
permanent damage to the transceiver if left there for
extended periods.
AVOID placing the transceiver in excessively dusty en-
vironments or in direct sunlight.
AVOID placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct
heat dissipation.
i

EXPLICIT DEFINITIONS

WORD
R WARNING
This
CAUTION
NOTE
Place unit in a secure place to avoid inadvertent use
at-
by children.
During mobile operation, DO NOT operate the trans-
ceiver without running the vehicle's engine. When the
transceiver power is ON and your vehicle's engine is
OFF, the vehicle's battery will soon become exhaust-
ed.
Make sure the transceiver power is OFF before start-
ing the vehicle. This will avoid possible damage to the
transceiver by ignition voltage spikes.
During maritime mobile operation, keep the transceiv-
er and microphone as far away as possible from the
magnetic navigation compass to prevent erroneous in-
dications.
BE CAREFUL! The heatsink will become hot when op-
erating the transceiver continuously for long periods.
BE CAREFUL! If a linear amplifier is connected, set
the transceiver's RF output power to less than the lin-
ear amplifier's maximum input level, otherwise, the lin-
ear amplifier will be damaged.
Use Icom microphones only (supplied or optional).
Other manufacturer's microphones have different pin
assignments, and connection to the IC-910H may
damage the transceiver.
DEFINITION
Personal injury, fire hazard or electric
shock may occur.
Equipment damage may occur.
If disregarded, inconvenience only.
No risk of personal injury, fire or
electric shock.