Resetting; All Reset; Partial Reset - Icom IC-80AD Instruction Manual

Resetting

The display may occasionally display
erroneous information (e.g. when first
applying power). This may be caused
externally by static electricity or by
other factors.
If this problem occurs, turn power OFF.
After waiting a few seconds, turn power
ON again. If the problem persists, per-
form either or both procedures below.

• All reset

Reset the CPU before operating the
transceiver for the first time, or if the
internal CPU malfunctions due to static
electricity, etc. All reset clears all pro-
gramming and returns all settings to
their factory defaults.

• Partial reset

Use Partial reset if you want to initial-
ize the operating conditions (VFO
frequency, VFO settings, set mode
contents) without clearing the memory
contents, call sign memories or re-
peater lists.
D All reset
q Push and hold [PWR] for 1 sec. to
turn power OFF.
w Push and hold simultaneously
[V/MHz], [M/CALL] and [
turn power ON to reset the CPU.
• "CLEAR" appears when resetting the
CPU (See the illustration below).
CAUTION: Resetting the CPU re-
turns all programmed contents to
their default settings.
OTHER FUNCTIONS
D Partial reset
q Push and hold [PWR] for 1 sec. to
turn power OFF.
w Push and hold [V/MHz], then turn
], then power ON to par tially reset the
transceiver.
NOTE: No message appears on the
display after the partial reset is done.
13
1
2
3
4
5
6
7
8
All reset
9
10
11
12
13
14
Partial reset
15
16
17
18
19
159