Beep Tones; Dial Speed Acceleration - Icom IC-80AD Instruction Manual

[DIAL]
t Push [V/MHz] to stop the scan.
• If the scan is cancelled before the transceiver detects the tone
or code, the set mode contents are not changed.
• The detected tone is used for temporary operation only. The
stored tone setting in memory or call channel won't be changed.
NOTE: Tone frequency is over-written automatically when it cor-
responds with the scanning tone frequency in tone squelch mode.
However, it is not over-written in memory or call channel mode.
Tone scan for repeater tone
Tone scan for tone squelch
Tone scan for DTCS squelch
OTHER FUNCTIONS

Beep tones

You can select to have confirmation beeps sound at the
push of a switch. The output level can be adjusted within 39
levels with "BEEPLV" in SOUNDS set mode (SET).
MENU SOUNDS BEEPLV (p. 130)
(Push [MENU ]), (Push [ ](2)/[ ](8), then push [
You can select silent operation by turning beep tones OFF
with "KEY B" in SOUNDS set mode (SET).
MENU SOUNDS KEY B (p. 130)
(Push [MENU ]), (Push [ ](2)/[ ](8), then push [

Dial speed acceleration

The dial speed acceleration automatically speeds up the
tuning dial speed when rotating [DIAL] rapidly.
This function can be turned ON and OFF with "DIAL S"
(DIAL SPEED) in FUNC set mode (SET).
MENU SET FUNC
(Push [MENU ]), (Push [ ](2)/[ ](8), then push [
13
](5).)
](5).)
DIAL S (p. 127)
](5).)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
153