Installing The Hanger Bracket - Hunter Type 2 Owners And Installation Manual

2-1. Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box. The pilot holes should be 9/64"
in diameter.
Note: Your fan comes with four pre-installed neoprene noise
isolators.
2-2. Thread the lead wires from the outlet box down through the hole
in the middle of the hanger bracket.
2-3. Align the slotted holes in the hanger bracket with the pilot holes
you drilled in the wood support structure. For proper alignment
use slotted holes directly across from each other. If you are
installing the fan on an ANGLED ceiling, be sure to orient the
hanger bracket as shown in Illustration 2-3 (left or right view).
Note: The isolators should be flush against the ceiling.
2-4. Place a flat washer on each of the two 3" screws and pass the
screws through the slotted holes in the hanger bracket into the
pilot holes you drilled.
Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws. Do not over tighten.
3" Screw
2 • Installing the Hanger Bracket
Flat Washer
Large
Opening
Step 2-3 (Angled Ceiling Only)
7
45075-01 • 03/29/11 • Hunter Fan Company
Isolator
Hanger
Bracket
Ceiling Peak Ceiling Peak
OR
LEFT RIGHT
Steps 2-2 – 2-4
Large
Opening