Installing The Canopy And Canopy Trim; Ring - Hunter Type 2 Owners And Installation Manual

5 • Installing the Canopy and Canopy Trim Ring
5-1. Partially install two canopy screws (about 2 full turns) in the
hanger bracket.
5-2. Raise the canopy over the hanger bracket. Align partially installed
screws with key slots in canopy.
5-3. Twist canopy clockwise to secure.
5-4. Install third & fourth canopy screw in round hole on canopy.
Securely tighten all four screws.
5-5. Using both hands, push the canopy trim ring up to the top of the
canopy.
5-6. Twist canopy trim ring clockwise to secure the canopy.
Should you need to remove the canopy
trim ring:
1. Twist canopy trim ring counter
clockwise until it releases from
canopy.
Canopy
Step 5-5
Screw
11
45075-01 • 03/29/11 • Hunter Fan Company
Steps 5-1 – 5-2 Hanger Bracket
Canopy Trim
Canopy
Step 5-4

Ring

Step 5-3