Hunter ceiling fan Installation Manual page 18

Operation, Maintenance, & Cleaning
ON
Install one (1) 12-Volt, type 23A,
the transmitter. Clean the battery
device prior to battery installation.
Note: Remove the battery from
the remote control transmitter if
correctly with regard to polarity
the product is to remain unused
(+ and -). Please contact your local
for an extended period of time.
battery recycling center for proper
To remove the battery, remove
the back cover of the remote
control transmitter. Remove used
batteries promptly.
+
12 V Battery
(Type 23A)
MN-21 battery (included) into
contacts and also those of the
Ensure the battery is installed
battery disposal information.
M3500-01 •11/30/12 • © Hunter Fan Company
Fan
Off
Low
Speed
To turn on fan, press a fan speed
button. Speeds range from off (0) to
high (3). The light button turns the
light on to full brightness. To dim
the light, hold the light button
down until you reach your desired
brightness. Push the light button
again to turn off the light.
18
www.HunterFan.com
Medium
Speed
High
Speed
Light
Removed
Tabs
To install the transmitter cradle, remove
the two screws holding the switch
cover plate. Do not remove the cover
plate. Orient the cradle by lining up
the two mounting holes with those on
the cover plate. Insert and tighten the
screws. Do not over tighten. Note: For
rocker-style cover plates, break off the
tabs by pushing outward.
1.888.830.1326
Switch
Cover
Plate
Rocker-
Style
Plate