Hunter ceiling fan Installation Manual page 10

Remote Control Settings
Transmitter
Jumpers
(Shown with transmitter door removed)
IMPORTANT! Before you change
the jumper settings, make sure
the battery is not connected to
the transmitter. Then change the
position of the jumpers in the
transmitter.
Receiver
DIP
Switches
Set the DIP switches in the
receiver to match the jumper
settings in the transmitter. If they
don't match, the controller will
not function.
10
M3500-01 •11/30/12 • © Hunter Fan Company
Example DIP Switch Settings
Receiver 1 Receiver 2
DIP Switches
DIP Switches Dip Switches Dip Switches
Set to 01110 Set to 01001
Set to 0111 Set to 0100
Transmitter 1 Transmitter 2
DIP Switches DIP Switches
Dip Switches Dip Switches
Set to 0111 Set to 01110 Set to 0100 Set to 01001
Example Jumpers Settings
Receiver 1 Receiver 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
Transmitter 1 Transmitter 2
4 3 2 1 4 3 2 1
4 3 2 1 4 3 2 1
4 = off 4 = off
3 =
3 = on on
4 = off 4 = off
2 = on 2 = off
3 =
3 = on 1 = on
1 = on on
2 = on 2 = off
1 =
1 = on on
Note: When two or more fans are
located near each other, you may
desire to have the receiver and
transmitter for each fan set to a
different code, so that the operation
of one fan does not affect the
operation of the other fans.
www.HunterFan.com
1.888.830.1326
_
+
CFL Toggle Battery
Switch
Set the CFL toggle switch
down in the direction that
reads "CFL." Install the
included 12-volt battery into
the transmitter.