Hunter ceiling fan Installation Manual page 14

Auto Balance™
Notch
Retaining
Screw
M3500-01 •11/30/12 • © Hunter Fan Company
Auto Balance
If you are using one of the
enclosed downrod assemblies,
it is now time for you to activate
the Auto Balance system by
removing the five red retaining
screws. Rotate the blades slowly
until one of the red retaining
screws is visible through the notch
in the mounting plate. Remove
the retaining screw from the
bottom of the fan housing using a
screwdriver. Repeat this process for
all 5 retaining screws.
Note: After the retaining screws
are removed, the blades will feel
loose. This is normal, as loose
blades are a characteristic of the
Auto Balance system
.
14
www.HunterFan.com
1.888.830.1326
Note: If you are using a downrod
assembly longer than 6 inches,
leave the retaining screws in
their place and continue the
installation process.