Network Setup - Q-See QSNDVR4R User Manual

4 Channel Digital Video Recorder
OVER WRITE: If set to YES, the DVR will automatically overwrite the HDD when the HDD is full. If
set to NO, the DVR will automatically stop recording when the HDD is full.
REC SPEED: The DVR factory default setting for the recording frame rate is 30F/SEC (frames/second)
under video standard NTSC (25F/SEC default under video standard PAL). This means the DVR
records events at the speed of 30 frames per second. The higher the recording speed rate, the more
natural look is displayed on the screen during playback. The lower the recording frame rate, the more
space is saved on the hard disk. The highest frame rate is 120F/SEC for NTSC (for PAL is 100F/SEC)
when the resolution is set as 360.
REC QUALITY: There are four different video quality settings: LOW, NORMAL, HIGH and VERY
HIGH. The higher the video quality is set, the clearer the images that are obtained during playback. The
lower the video quality is set, the more space is saved on the hard disk drive.
RESOLUTION: The recording picture size of the DVR has two modes: 360 and 720. The default
value is 360. In 720 mode, the recorded picture is twice as large than in 360 mode. In 360 mode the REC
speed is fixed at 120F/SEC for NTSC (100F/SEC for PAL) and the maximum REC SPEED in 720 mode
is 60F/SEC for NTSC (50F/SEC for PAL).
PB SPEED: The default playback frame rate is shown as NO USE, which means that it is the same as
REC SPEED.
AUDIO ENABLE: When set to ON, the DVR will record in one channel. This channel has to be
selected among the four available channels. The default is CH1. The audio signal playback is only
possible through the DVR.
13. Network Setup (May require IT expertise)
When the cursor moves to NETWORK SET in the SETUP MODE Top Main Menu, pressing the
19