3: Network Setup; 1: Dhcp; 2: Pppoe; 3: Static - Q-See QC-SERIES User Manual

5.2.3: Network Setup

(Picture 9)
(Picture 10)
The right click menu in the Main Interface mode (Picture 3) allows you
to access the Main Menu interface (Picture 4). To set up the Network
settings of your DVR, go to [Main Menu] [Network Set] to enter into
[Network Setup] menu (Picture 9).
From the Network Setup menu (Picture 9), you can choose your
Network Type (DHCP, PPPoE, or Static), Port and Web Port (80 and
9000 by default) from a drop down list. Once you have configured
these, you can then view the DVR remotely over a network or the
internet.

5.2.3.1: DHCP

When selecting DHCP as your Network type, your Router will allocate
a DVR IP address automatically once you exit the Network Setup
menu.
recommended you switch to the "Static" Network Type and enter the
address information here to avoid any discrepancies that might occur
in the event your Router auto generates a different address in the
future.

5.2.3.2: PPPoE

When selecting PPPoE as your Network type, you will need to input a
user and password provided by your internet service provider. Once
you have obtained those settings from your internet service provider,
you will need to set your web port as illustrated in Picture 10.
(Picture 11)
QSDR16RTCB User Manual
Write down the address assigned by your Router.

5.2.3.3: STATIC

When selecting Static as your Network type, you will
need to set the Network setting on the DVR to match
settings of your Router. To do this, bring up the
command prompt on any computer attached to your
Router by typing cmd into your Run program
(Picture 11). Type in ipconfig at the prompt (see
red arrow on Picture 11) to access the router
settings. Write down the gateway and subnet mask
numbers (Green arrows on Picture 11) so you can
enter them into the network settings of the DVR
(Picture 12).
12
It is