Securing The Treadmill With A Password; Creating A User Name - Precor 9.35 Owner's Manual

WARNING: If you choose to change the
security of the treadmill, it is your respon-
sibility to make sure that no unauthorized
personnel or children are allowed on or
near the treadmill.

Securing the Treadmill with a Password

Note: The password protection program is part of a three-part sequence that starts with
Selecting a U.S. Standard or Metric Display. Begin with the instructions on page 32.
If you chose step 4a. or 4b. in the previous programming step, the prompt, PASS-
WORD appears on the display. You can use the
available options:
Password Enabled — causes the password prompt to appear prior to working out
and when returning from Pause mode.
Password Disabled — lets you "turn off" the password requirement. Use this option
with caution.
Once your selection is displayed, three options exist. You can,
1. Press Enter to accept the displayed information and continue with programming
the treadmill. The changes have been retained in the treadmill's memory. The
M9.35 treadmill will retain your selection even when it is turned OFF and
unplugged.
2. Press Stop which keeps the current security unchanged and lets you continue
with programming the treadmill.
3. Press Reset which keeps the current security unchanged, ends the program-
ming mode, and returns to the Precor banner.

Creating a User Name

Note: Replacing the User1, User2, User3, or User4 identification with a user name, is
part of a three-part program that starts with Selecting a U.S. Standard or Metric
Display. Begin with the instructions on page 32.
If you chose step 1 or 2 in the previous programming step, the prompt, USER NAMES
appears on the display. A user I.D. (i.e. USER1, USER2, USER3, USER4) appears in the
lower display. The name associated with the user I.D. appears in the upper display.
(If no user name has been created, then the user I.D. appears in both places.) The first
character (in the upper display) blinks indicating that the treadmill is awaiting your input.
Important: A user name is limited to five characters. The name "FRANK" is acceptable,
but "MARCIA" is not.
To create or change the name, take the following steps:
1. Use the Speed key to advance through the alphabet. When the correct charac-
ter appears, press Incline
(The Incline key moves the cursor to the left.)
Note: Pressing Quick Start for about five seconds while the User I.D. is being
displayed, restores the default user name, User 1, User 2, etc.
2. Once your selection is displayed, two options exist. You can,
a. Press Enter to accept the name being displayed and advances to the next
user I.D. The changes have been retained in the treadmill's memory. The
M9.35 treadmill will retain your selection even when it is turned OFF and
unplugged.
b. Press Stop to keep the current User I.D unchanged and advance to the next
User I.D. Once all four user I.D.'s have been displayed, pressing Stop or
Reset exits the program mode and returns the Precor banner.
Note: The "current User I.D" is not necessarily the one being displayed. It refers
to the user I.D's that were in existence prior to entering the program mode.
keys to cycle through the
to move the cursor right to the next character field.
page 33