Yamaha RX-V1200 Owner's Manual page 45

You can control other components by setting a
manufacturer code. A code can be set up in each
component control area.
The following table shows factory-set component
(Library: component category) and the manufacturer code
for each area.
Input area
Component category Manufacturer
(Library)
A LD YAMAHA
PHONO TV -
TUNER TUNER YAMAHA
CD CD YAMAHA
V-AUX VCR -
CBL/SAT CABLE -
MDfI'APE MD YAMAHA
CD-R CD-R YAMAHA
D-TV/LD TV -
VCR 1 VCR -
VCR 2/DVR VCR -
DVD DVD YAMAHA
[] Press an input selector button or _ to select
the component you want to set up.
ZZ9
OOQ_
I!_ 1il
P_i::
i_i iij iii
.......... . .. m .............
[] Press and hold LEARN for about 3 seconds
by using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
|'_i; i_i;ii i
_ZZi i!Z!::i J iJ J
!!1!
• Press LEARN for at least 3 seconds, otherwise the learning
process is started.
• If you do not press any button within 30 seconds during step 3,
the setup process is canceled. If this happens, start over from
step 2.
[]
j!:l_[eJl:l[Ke]_Vll;{e]li_:r'__ll];/:_
Press A / v to select the name of your
component's manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
^
< >
ii!i iii i!!i
I I
I I
I
If you want to change a library (component
category), press < / >. You can set a different
component from the input selector name.
Library choices: DVD, LD, CD, CD-R, MD, TAPE,
TUNER, TV, CABLE, DBS, SAT, VCR
i!r
If the manufacturer of your component has more than one codes,
try each of them until you lind the correct one as checking if it
works following step 4.
"_J Press one of the buttons shaded below to
check if it works for the
component being
set. If it does, the manufacturer code setting
has been correctly made.
po_R _R AMP
LEVEL ^ _MENU MUTE
\I/
z_ __
• If you continuously want to set up another code for another
component, press TV MUTE/SELECT and repeat steps 1,3
and 4.
_1 Press LEARN again to exit from the setup
mode.
• If you have already programmed a remote control function for
a button, the function by learning programming takes priority
over the setup manufacturer code's function.
• "ERROR" appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
I
43