Yamaha RX-V1200 Owner's Manual page 30

l : Y,_ T _'q [ oJ[ ".lW,_ t "4 :Y,_ T Ol;
You can enhance your listening experience by selecting a
DSP program. There are 10 programs with sub-programs
available with this unit. However the selection depends on
the input signal format and not all the sub-programs are
possible for all input signal formats. For details about
each program, see pages 31 to 35.
2
[] After selecting the desired program, press
the same button repeatedly to select the
desired sub-program if available.
For example, to select the sub-program "70 mm
Spectacle", press MOVIE THEATER 1 repeatedly.
Program name
ivAo .......... .................... ......
............. o.................. ,_ _ [_i
l
Sub-program name
[]
2,3
Press AMP to select the AMP
AMP mode.
Press PROGRAM <] / _> (one of the numeric
buttons on the remote control) to select the
desired program.
The name of the selected program appears on the
front panel display and on the video monitor.
Front panel Remote control
Program name
V-AUX _2 VCR 1 _SAT D-_LD D_ MD_ CO-R _NER CD P_NO
MOVIE THEATER 1
r, ,,,,, ,.:........
.., i L. _.,.,,.,.,,,,,,i, -.,,-, 'I ,.,.,
=:1' =,,,' :,,' ':3 k,,' ,I,
1
Sub-program name
• Choose a DSP program based on your listening preference, and
not on the name of the program. The acoustics of your listening
room affect the DSP program. Minimize the sound reflections
in your room to maximize the effect created by the program.
• When you select an input source, this unit automatically selects
the last DSP program used with that source.
• When you set this unit in the standby mode, the current source
and DSP program are memorized and are automatically
selected when you turn on the power again.
• If a Dolby Digital or DTS signal is input when the input mode
is set to AUTO, the DSP program (No. 8-10) automatically
switches to the appropriate decoding program.
• When a monaural source is being played with PRO LOGIC/
Normal or PRO LOGIC/Enhanced, PRO LOGIC 1T Movie, or
Neo: 6 Cinema, no sound will be heard from the main speakers
and the rear speakers. Sound can only be heard from the center
speaker. However, if "1A CENTER SP" on the SET MENU is
set to NONE, the center channel sound is output from the main
speakers.
• When a source connected to the 6CH INPUT jacks of this unit
is selected, the digital sound field processor cannot be used.
• When 96-kHz sampling digital signals are input to this unit, the
DSP program cannot be selected. In this case, the sound is
reproduced as normal 2-channel stereo.
28