Working With The Machine - Festool T12+3 Instruction Manual

Angle attachment DD-AS
The angle attachment DD-AS (partly accessories)
allows you to work (drill, fasten) vertically in rela-
tion to the longitudinal axis on the machine.
DD-AS
6-1
Fitting the angle attachment DD-AS
Fit the angle attachment to the drill spindle.
Turn the attachment until is engages in the re-
quired position.
You can engage the angle attachment in 16 dif-
ferent positions.
Turn the securing ring [6-2] firmly clockwise to
lock the angle attachment.
Removing the angle attachment DD-AS
Turn the securing ring [6-2] anticlockwise all
the way.
Remove the angle attachment.
Attaching/Detaching the chuck
The chuck is secured to the shaft [6-1] of the angle
attachment and the drill spindle on the machine in
the same way.
Eccentric attachment DD-ES
The eccentric attachment (partly accessories) en-
ables you to fasten close to abutting edges. The tool
holder was designed for bits in accordance with DIN
3126.
DD-ES
7-1
Consider the pictures on the fold-out page.
Switch on/off
The switch [1-3] is an on/off switch (press = ON, re-
lease = OFF).
Attaching/Detaching eccentric attachment DD-ES
The eccentric attachment is attached/detached in
the same way as the angle attachment (Section
"Angle attachment DD-AS").
Changing tools
6-2
The depth stop (partly accessories) allows you to in-
sert a screw to a defined fastening depth.
DD-DC
Attaching/Detaching depth stop DD-DC
The depth stop is attached/detached in the same
way as the angle attachment (Section "Angle at-
tachment DD-AS").
Changing bits
Depth adjustment

Working with the machine

Pull the release ring [7-1] back.
Insert or remove the tool.
Release the ring [7-1].
Depth stop DD-DC
8-1 8-2 8-3
Turn the stop [8-1] 90° anticlockwise and re-
move.
Remove the bit or insert a bit into the magnet
holder [8-4].
Fit the stop [8-1] again and tighten by turning
90° clockwise.
Turn the sleeve [8-2] to set the required fasten-
ing depth.
Each notch stage alters the fastening depth by
0.1 mm.
To remove screws, turn the green reversing
ring [8-3] anticlockwise until the screw is re-
moved (anticlockwise rotation!).
The speed of the machine depends on how far
the ON/OFF switch is pressed in.
When the ON/OFF switch is released, the work-
ing spindle (chuck) stops immediately.
8-4
13