Working With The Machine - Festool DWC 18-2500 Original Instructions Manual

English

10 Working with the machine

10.1 Switching on/off [1-2]
The tool is not started by pressing the
switch [1-2] alone – not a tool fault!
Once the screw is driven to the de­
sired depth, the tool switches off au­
tomatically.
There are numerous ways to switch the tool on:
[1-4] [1-3]
a) MAN
CLOCKWISE
b) AUTO
ANTI-CLOCKWISE
c) -
ANTI-CLOCKWISE
a)
► Set the tool's rotational direction to clock­
wise using the right/left switch [1-3].
► Move the selector switch [1-4] to the MAN
position.
► To switch the tool on, actuate the
switch [1-2] and at the same time, press on
the screw with the drill bit.
By pressing on the switch [1-2], the speed can
be infinitely adjusted.
b)
► Set the tool's rotational direction to clock­
wise using the right/left switch [1-3].
► Move the selector switch [1-4] to the AUTO
position.
► To activate the tool, press on the screw with
the drill bit.
It is not necessary to press the switch [1-2].
The top speed is set automatically.
c)
► Set the tool's rotational direction to anti­
clockwise using the right/left switch [1-3].
► Switch the tool on using the switch [1-2].
The MAN/AUTO selector switch [1-4] is in
either position.
By pressing on the switch [1-2], the speed can
be infinitely adjusted.
The drywall screwdriver rotates anti­
clockwise by pressing on the
switch [1-2] only, without also having
to press on the bit.
12
[1-2] [1-6]
PRESS PRESS
- PRESS
PRESS -
To unscrew screws fully, the depth
stop does therefore not need to be re­
moved.
10.2 Depth stop
Turning on the depth stop [4-1] sets the screw­
ing depth, as shown in figure [4]. The setting is
accurate to approx. ± 0.1 mm.
Anticlockwise rota­
tion
Clockwise rotation
Once the depth setting is made, drive in a test
screw then, if necessary, correct the depth.
4
4-1
Attaching the depth stop
► Place the depth stop [5-1] on the transmis­
sion housing [5-2].
► Then, apply pressure until the depth stop
audibly clicks into place.
5
5-1
Removing the depth stop
► Take the depth stop out of the transmission
housing by pulling firmly.
Screw is countersunk
further out.
Screw is countersunk
further in.
5-2