Festool CMS OF GE Supplemental User's Manual page 9

6. If the outrigger foot is installed on your router, remove
it and replace it with the alignment tab. Make sure the
smaller of the tabs (4mm) is toward the base of the
router.
Outrigger
Alignment
Tab
7. While holding the dust shroud from falling out, invert the
router onto the CMS table. Hint: To hold the dust shroud
in place, press against the dust shroud by inserting your
finger between the motor and the router base.
8. Place the router over the centering ring with the 4mm
alignment tab in the smaller hole on the CMS baseplate.
9. Wiggle the router to ensure it is fully seated over the
centering ring.
Alignment
Tab and Hole
Supplemental Owner's Manual
Foot
4mm Tab
6mm Tab
10. Install the 3 clamping dogs to the threaded standoff in
the CMS baseplate. The flat, shorter leg goes against
the router base.
Clamping
Dog
For Router
Baseplate
11. Position the 3 clamping dogs on the router base and
firmly tighten the thumbscrews. Make sure that the
dogs are not positioned over curved parts of the base
otherwise they could slip off.
12. Make sure the router cannot move or wiggle.
For CMS
Table
9