Festool CMS OF GE Supplemental User's Manual page 12

3. Place the OF 1400 centering ring in the opening of the
baseplate.
Part number 473809 is printed on the back. This side
►
faces the router.
4. Compress (lower) the router's plunge and tighten the
plunge lock knob. (Make sure the turret and depth stop
are set to their lowest position.)
5. If the outrigger foot is installed on your router, remove
it and replace it with the alignment tab. Make sure
the larger of the tabs (6mm) is toward the base of the
router.
Alignment
Tab
12
This side up
toward router.
Outrigger
Foot
6mm Tab
4mm Tab
6. Invert the router onto the CMS table.
7. Place the router over the centering ring with the 6mm
alignment tab in the larger hole on the CMS baseplate.
8. Wiggle the router to ensure it is fully seated over the
centering ring.
9. Install the 3 clamping dogs to the threaded standoff in
the CMS baseplate. The flat, shorter leg goes against
the router base.
Clamping
Dog
For Router
Baseplate
Alignment
Tab and Hole
For CMS
Table
CMS OF Router Table