Festool CMS OF GE Supplemental User's Manual page 10

13. Place the height adjustment crank on the top of the
leadscrew and lower the height adjustment tab until it
almost touches the router. (It will be easier to invert
the table when the router is plunged low.)
14. Release the plunge lock knob and slowly raise the
router plunge until it touches the height adjustment
tab.
15. Don't forget to remove the crank handle before invert-
ing the table.
16. Make sure the flat edge of the table latches are parallel
with the table so they do not get in your way as you
invert the table.
17. Using the 2 finger holes, lift the front edge of the
baseplate out of the base.
18. Grasp the baseplate by the side edges and lift it the
rest of the way out of the base.
19. Carefully invert the baseplate and router.
20. While holding the baseplate level, begin lowering it
into the table until the height adjustment leadscrew is
through the opening in the base.
21. Tilt the rear of the baseplate and engage it into the
hinge at the rear of the base.
22. Grasp the baseplate with the finger holes and finish
lowering it into place.
Hinge
10
Height Adjust-
ment Crank
Height Adjust-
ment Tab
Plunge
Lock Knob
Finger
Holes
23. Turn the 2 table latches clockwise to lock the baseplate
in the base.
24. If necessary, insert the height crank into the table to
raise or lower the router.
25. The kit includes throat plates of various sizes that snap
into the router's centering ring. Use the throat plate
with the smallest opening that clears the router bit.
Table
Latches
Centering
Ring
Router Height
Crank
Table
Latches
Throat
Plate
CMS OF Router Table