Positioning The Seat; Adjusting The Motion Control Levers - Toro TimeCutter Z5030 Operator's Manual

Using the Foot Assist Pedal (Model
74375 only)
The foot assist pedal can be used with the height of cut
lever to help adjust the deck height.
.
.
Enter the operator's position. Place a foot on the
foot assist pedal and apply pressure.
\While maintaining pressure on the pedal, pull
inward and up on the height-of-cut lever and move
it to the desired position.
Figure 19
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment knob just
enough that seat can move (Figure 20).
1
\
1. Adjustment knob
Figure 20
2. Move the seat to the desired position and tighten
the knob.
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 2i).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 2i).
2O