Stopping The Engine; The Safety Interlock System - Toro TimeCutter Z5030 Operator's Manual

G005059
Figure 13
1. Control panel 2. Blade control switch--On
position
Disengaging the Blades
Push down on the blade control
switch to move it to
the Off position and disengage the blades (Figure 14).
1. Control panel
G005056
Figure 14
2. Blade control switch--Off
Stopping the Engine
1. Disengage the blades by moving the blade control
switch to Off (Figure i4).
2. Move the throttle lever to between Fast and half
throttle (Figure i2).
3. Turn the ignition key to Off (Figure 11) and remove
the ke>
The Safety Interlock System
If safety interlock switches are disconnected
or damaged the machine could operate
unexpectedly causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
engine from starting unless:
• The blades are disengaged.
• The motion control levers are in the park position.
The safety interlock system also is designed to stop
the engine when the control levers are out of the park
position and you rise from the seat when the blades
are engaged.
Testing the Safety Interlock System
Test the safety interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized Service
Dealer repair the safety system immediatel>
1. While sitting on the seat, with the control levers in
park position, and move the blade control switch
to On. Try starting the engine; the engine should
not crank.
.
While sitting on the seat, move the blade control
switch to Oft, Move either motion control lever
to the center, unlocked position. Try starting the
engine; the engine should not crank. Repeat with
the other morion control lever.
.
.
While sitting on the seat, move the blade control
switch to Off, and lock the motion control levers in
the park position. Start the engine. While the engine
is running, engage the blade control switch, and rise
slightly from the seat; the engine should stop.
While sitting on the seat, move the blade control
switch to Off, and lock the motion control levers
in the park position. Start the engine. While the
engine is running, move the morion control levers
to the center, unlocked position, engage the blade
control switch, and rise slightly from the seat; the
engine should stop.
17