Audiotrak Prodigy 192 Manual page 18

1. MIC IN (pink)
Connect to an external microphone for voice input. You cannot use this MIC input
and below Line input at the same time.
2. LINE IN (blue)
This is analog stereo Line input.
Connects to an external device (such as a Cassette, DAT, or Mini Disc player).
You cannot use MIC input and this Line input at the same time.
3 & 4. Analog Outputs 1,2 (Green) and 3,4(black)
These are stereo Analog Outputs 1,2 and 3,4. Analog 1,2 send out the signal indicated as
'1-Prodigy 192 2ch' on application's device set up. Analog 3,4 send out the signal
indicated as '2-Prodigy 192 2ch' on application's device set up.
When you use Software DVD player, Analog Output 1,2 will be Front Left, Right.
Analog Output 3,4 will be Rear Left, Right.
5. Analog Outputs 5,6(yellow)
Stereo Analog Outputs 5,6 send out the signal indicated as '3-Prodigy 192 2ch' on
application's device set up. When you use Software DVD player, It will be Center and
Woofer.
This output port is also used as headphone connector. Prodigy 192 provides high
quality headphone amp.
* In Winamp or Media Player, If you want to use virtual 5.1 channel, choose
"Clone 4way from Out 1-2" on Config Option of Prodigy Console.
6.7. Optical & Coaxial Out/AC3 (Dolby digital)
These ports can transfer Prodigy's audio data without loss, directly to a DAT, MD, CD-
recorder, which support digital connection.
This port sends out the signal indicated as '4-SPDIF-AC3' on application's device set
up, and also sends out AC3 encoded Dolby Digital signal.
When you playback DVD title on a software DVD player, you can easily make surround
sound environment using the port and AV receiver with decoder.
In this case, software DVD player and DVD title must support AC3 digital thru function
Caution: When connecting the optical cable, never point the optical connector directly into
your eyes, as the light can cause eye damage.
18