Master Out Fader; Input Select - Audiotrak MAYA44 Manual

4. 'M' – Analog 1,2 Master Output / Monitoring – This button is most important. The function is that
send wave output to Analog out 1,2 port and you can monitor it. So Analog Out 1,2 becomes Master
Output.
- Wave 1,2 On – Wave Out 1,2 goes to Analog Output port 1,2.
- Wave 1,2 Off – Wave Out 1,2 doesn't goes to Analog Output port.
- Wave 3,4 On – Wave Out 3,4 goes to Analog Output1,2 and 3,4.
- Wave 3,4 Off – Wave Out 3,4 only goes to Analog Output3,4.
*** Caution – When you press H-Phone button of Control Panel, Analog Output port 3,4 become
headphone port.

3. Master Out Fader

The Master Out Fader controls the entire output level of the MAYA44.

4. Input Select

This Input Select area is where you select your first input source that display as '1-MAYA 44 Wave.' This
input can be used as Line, Mic, and CD inputs. You can adjust level and monitor source through IN 1.2
fader. Second Input device '2-MAYA 44 Wave' only use in Analog Input port 3,4.
Ex) If you want to record an audio CD in Cakewalk,
1. Select 'CD' in 'Input Select' on the MAYA44 control Panel.
2. Select '1-MAYA44 Wave' for your recording source in Cakewalk.
1. LINE – line input select
If 'Line' is selected for inputs 1,2 on the MAYA44 Control Panel, the MAYA44 will take the –10dBV line
input as its source. The rest of the inputs, inputs 3,4 will always take the –10dBV line inputs as its source.
2. MIC – Mic Input select
The MAYA44 can record audio from microphones. A mic can be connected Input 1,2. However you can
use one mono microphone.
43