Cannot Print Over A Network; Cannot Connect The Printer To The Network; Cannot Print Over A Tcp/Ip Network - Canon iPF650 - imagePROGRAF Color Inkjet Printer User Manual

Cannot print over a network

Cannot connect the printer to the network

Cause
The Ethernet cable is not connected
correctly to the printer's Ethernet port.

Cannot print over a TCP/IP network

The printer's IP address is not congured correctly.
The printer's TCP/IP network settings are not
congured correctly.
The computer you are trying to print from is not
congured correctly.
1.
Make sure the printer is connected to the network with the correct
Ethernet cable, and then turn the printer on. For instructions on
connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The bottom indicator is green if the printer is connected via
1000Base-T, while the top indicator is orange if connected via
100Base-TX and the top indicator is green if connected via
10Base-T.
If the Link indicator is not lit, check the following points.
Cause
Corrective Action
•
Make sure the hub is on.
•
Make sure the end of the Ethernet cable is connected
correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the hub.
Although the printer normally detects the hub
communication mode and transmission rate automatically
(in auto negotiation mode), sometimes the hub settings
cannot be detected. In this case, congure the connection
method manually, specifying the communication mode in
use.
(→P.578)
Make sure the printer's IP address is congured
correctly.
(→P.564)
(→P.565)
Make sure the printer's TCP/IP network settings are
congured correctly.
(→P.570)
Make sure the computer's TCP/IP network settings
are congured correctly.
(→P.581)
(→P.600)
Cannot print over a network
Corrective Action
Troubleshooting 679