Table of Contents
Advertisement
Blank screen
Maybe the device connected
to the input jacks
is not turned on.
Try another channel.
Press RESE-[_ in case the picture
controls
are set too low.
No sound, picture
okay
Maybe sound is muted. Try pressing volume up button to restore sound.
Maybe TV's speakers are turned off. Check the Audio Output and Speakers control panel in the Audio menu.
If using an S-VHS component, remember to also connect the component'a L and R AUDIO OUTjacks
to the TV's L
and R INPUT l jacks.
Can't
select certain
channel
Channel may be blocked or not approved in the Parental Controls menu.
If using a VCR, check to make sure the TV/VCR switch on the VCR is in the correct position.
Noisy
stereo reception
May be a weak station. Use SOUND button to change to mono mode instead of stereo.
No
picture,
no sound
but
TV is on
Maybe the cable/air
function
is set to the wrong position.
Maybe a vacant channel
is tuned.
If watching
VCR (connected
only through
antenna
input), make sure TV is tuned to channel
3 or 4 - same as CH3/4
switch
on VCR. Also check to make sure TV/VCR switch
on VCR is in correct
position.
Sound okay, picture
poor
Check antenna connections.
Try adjusting sharpness function to improve weak signals,
Black Box appears
on the screen:
Captioning may be turned on. Check the Closed-Caption Display control panel in the Channel menu.
TV GUIDE
Plus+
IR Controllers
not
working
Check to make sure the controllers
are positioned
correctly
over the IR remote sensors.
Your remote may be interfering
with the IR controller.
Place a piece of dark tape over the IR controller.
TV GUIDE
Plus+ control
of a cable box is slower than direct control
of the box itself. Keep this in mind when
changing
channels.
79
Advertisement
Table of Contents
