Zanussi ZWGB 7140 K User Manual page 16

Problem
The appliance does not
drain the water.
The spin phase does
not operate
or
the washing cycle lasts
longer than usually.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise.
The appliance fills with
water and drain immedi-
ately.
The washing results are
not satisfactory.
After the check, activate the appliance. The pro-
gramme continues from the point of interruption.
16
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is correct.
Make sure that the sink spigot is not clogged.
Make sure that the water drain hose has no kinks or bends.
Make sure that the connection of the water drain hose is correct.
Set the drain programme if you set a programme without the drain phase.
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
Adjust manually the items in the drum and start the spin phase again. This problem
may be caused by balance problems.
Set the spin programme.
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
Make sure that the couplings of the water hoses are tight and there are no water
leakages.
Make sure that the water inlet hose and the water drain hose has no damages.
Make sure you use the correct detergent and the correct quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure that the leveling of the appliance is correct. Refer to 'Installation instruc-
tion'.
Make sure that the packaging and/or the transit bolts are removed. Refer to 'Instal-
lation instruction'.
Add more laundry in the drum. The load may be too small.
Make sure that the drain hose is in the correct position. The end of the hose may
be is too low. Refer to 'Installation instruction'.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Possible solution
If the problem occurs again, contact the Serv-
ice.
www.zanussi.com