1. Manuals
  2. Brands
  3. Zanussi Manuals
  4. Washer
  5. ZWG 6160 P
  6. User manual

Zanussi ZWG 6160 P User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

User manual
EN
Washing Machine
ZWG 6160 P

Advertisement

Table of Contents
loading

Related Manuals for Zanussi ZWG 6160 P

Summary of Contents for Zanussi ZWG 6160 P

  • Page 1 User manual Washing Machine ZWG 6160 P...

  • Page 2: Table Of Contents

    Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Frost precaution _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4...
  • Page 3 not pressing the electrical supply cable against the • The detergent dispenser drawer is provided with an in- wall. sert for liquid detergent. Do not use the insert down- wards for gelatinous detergents, with programmes in- • Install the appliance on a flat hard floor. cluding prewash, with the delay start option.

  • Page 4: Frost Precaution

    To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise until groove is horizontal. If the groove is vertical. necessary use a coin.

  • Page 5: Product Description

    >PP<=polypropylene • The machine works more economically if it is fully loa- This means that they can be recycled by disposing of ded. them properly in appropriate collection containers. • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a Ecological hints lower temperature.

  • Page 6: Installation

    Electrical connection Information on the electrical connection is given on the rating plate, on the Voltage - Overall power - Fuse inner edge of the appliance door. Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 6 kg Spin Speed Maximum 1600 rpm...
  • Page 7 • Open the door and re- Warning! Do not re- move the plastic hose move the drain hose guide, the bag contain- from the rear support. Re- ing the instruction move this hose only if it is booklet and the plastic necessary to drain the wa- plug caps from the ter.
  • Page 8 Positioning and levelling 35° 45° Loosen the ring nut to angle the hose to the left or right depending on the position of your water tap. Do not place the inlet hose downwards. After positioning the inlet hose, be sure to tighten the ring nut again to pre- vent leaks.
  • Page 9 • Directly to a built-in drain pipe in the room wall. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to pre- The drain hose may be extended to a maximum of 4 vent waste from the sink entering the appliance.

  • Page 10: Special Accessories

    • Always use a correctly installed shockproof socket. • Make sure that the mains plug is accessible after in- stallation. • Do not use multi-way plugs, connectors and extension cables. There is a risk of fire. • Do not pull the mains cable to disconnect the appli- ance.
  • Page 11 Grass: soap lightly and treat with bleach (whites and fast Close the door gently coloureds only). Warning! Make sure Ball point pen and glue: moisten with acetone , lay the that any fabrics were garment on a soft cloth and dab the stain. not trapped when closing Lipstick: moisten with acetone as above, then treat stains the door.
  • Page 12 If the water hardness degree is medium or high we sug- • Remove the drawer. Push the drawer edge outwards gest you to add a water softener following always the where indicated by the arrow (PUSH) to facilitate manufacturer’s instructions. drawer removal.
  • Page 13 Measure out the fabric softener Warning! Do not use the flap in "DOWN" position with: Pour fabric softener or any • Gelatinous detergent or thick detergent. additives into the compart- • Powder detergent. ment marked (do not • With programmes with prewash. exceed the «MAX»...
  • Page 14 Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 7 starts flashing: the appliance is now switched on. Programme selector dial If you turn the programme selector dial to another programme when the appliance is working, the red pilot light of the button 7 will flash 3 times to indicate a wrong selection.
  • Page 15 Extra Rinse This appliance is designed for saving water. However, for people with very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water. Press simultaneously the buttons 3 and 4 for some seconds: the pilot light 6.2 comes on.
  • Page 16 Start the programme by pressing the button 7 • To start the selected programme, press the button 7, the corresponding green pilot light stops flashing. The pilot light 6.1 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the appliance will begin the countdown.

  • Page 17: Washing Programmes

    Washing programmes Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry COTTONS (Katoen/Coton) AUTOMATIC SPIN RE- 90°-Cold DUCTION, Main wash - Rinses - Maximum spin speed at: 1600 rpm NO SPIN, DELAY START, Max.
  • Page 18 Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry - HANDWASH / - WOOL (Wol/Laine - Handwas/Lavage à la main) 40°- Cold AUTOMATIC SPIN RE- Main wash - Rinses - Maximum spin speed at 1200 rpm DUCTION, Max.

  • Page 19: Consumption Values

    Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry MINI 30 30° AUTOMATIC SPIN RE- Main wash - Rinses - Maximum spin speed at 700 rpm DUCTION, Max.

  • Page 20: Care And Cleaning

    Care and cleaning Warning! Switch the appliance off and remove the mains plug from the socket before any cleaning action. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis.
  • Page 21 • open the filter cover by pressing the special hook and by rotating the cover upwards; Warning! Keep the filter cover open un- til the filter removal. • before removing the fil- ter, remove any fluff or small objects from around the filter;...

  • Page 22: What To Do If

    • Screw the hose back onto the tap. Make sure the • Unscrew the hose from connection is tight. the appliance. Keep a towel nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth.
  • Page 23 Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emer- gency drain: •...
  • Page 24 Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. The appliance does not start: •...
  • Page 25 Malfunction Possible cause / Solution The electronic unbalance detection device has cut in because the laundry is not even- ly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
  • Page 28 www.zanussi.com/shop...

Table of Contents