Removing The Base Grille; Cold Water And Ice Dispenser - Whirlpool ED25PWXTW00 Use & Care Manual

Removing the base grille...
To remove,.
1. Open the doors.
2. Pull grille outwards as shown.
3. Do not remove Tech Sheet fastened behind
grille.
METAL CLIPS
SUPPORT TABS
TO replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
Cold water and ice dispenser...
FOR ICE:
Press a sturdy glass
against the ice dispenser bar.
(Pressure and tumbling ice
can break a fragile glass.)
Remove the glass to stop
dispensing.
The first few batches of ice
from the ice maker may have
a bad taste from new plumb-
ing and parts. Throw them
Press against Ice Dispenser Bar
FOR CHILLED WATER:
Press a sturdy glass
against the water dispenser
bar. (Pressure can break a
fragile glass.) Remove the
glass to stop dispensing.
Dispense enough water
every week to maintain a
fresh supply.
away.
The small tray beneath the dispenser is designed to evaporate small
spills. There is no drain in this tray. Do not pour water into it.
Ice is dispensed from the ice maker storage bin in
the freezer. When the dispenser bar is pressed, a
trapdoor opens in a chute between the dispenser and
the ice bin. Ice is moved from the bin and falls through
the chute. When the dispenser bar is released, a faint
buzzing sound may be heard for a few seconds.
Chilled water comes from a tank behind the meat
drawer. It holds about 50 ounces (1.5L).
When the refrigerator is first hooked up press the
water dispenser with a glass or jar until you have
drawn and discarded 2 or 3 quarts (1.9 to 2.8L).
The water you draw and discard will rinse the tank
and pipes.
Allow several hours to chill the first tankful.
NOTE: Large amounts of ice should be taken from the bin, not through the dispenser.
Common Problems
PROBLEM
Dispenser won't work.
Ice dispenser won't
work.
Ice dispenser stops
working.
Off-taste or
odour in ice.
CAUSE
Freezer door open.
Ice bin not properly installed.
Wrong ice in bin.
Ice dispenser bar held
in too long.
Ice attracts airborne odours.
Old ice.
Water quality.
Foods not properly wrapped.
Ice bin and freezer may need
cleaning.
Plumbing to ice maker.
New ice maker.
SOLUTION
• Close the freezer door.
• Make sure bin is pushed all the way in.
• Use only ice crescents from ice maker.
Other shapes won't dispense properly.
• Wait about 3 minutes for the dispenser
motor to reset.
• Large amounts of ice should be taken
from the bin, not through the dispenser.
• Use rapidly or store in covered container.
• Dump old ice and make new supply.
• Water containing minerals (such as sulfur)
may require a filter to remove.
• Wrap properly. See pages 13 and 14.
• Clean freezer and ice bin. See Cleaning
Chart on page 11.
• Follow installation instructions for proper
ice maker water supply hook-up.
• The first few loads of ice from a new ice maker
may have an off-taste. Dump ice and make
new supply.