Troy-Bilt TB75SS Operator's Manual page 14

4.
Use a clean cloth to clean the the inner reel, spring,
shaft, and inner surface of the outer spool.
5. Check the indexing teeth on the inner reel and outer
spool for wear (Fig. 14). If necessary, remove burrs or
replace the reel and spool.
....................................... iiiiiiiiiiii .......................................
For Use with
Single Line ONLY
/
f
/
For Use with Membrane
or Single Line
/
Slotted Holes
Fig: _5
i
Loop
NOTE: Membrane line can only be used with the
inner reel with the slotted holes. Single line can be
used on either type of inner reel. Use Figure 15 to
identify the inner reel you have.
NOTE: Always use the correct line length when
installing trimming line on the unit. The line may not
release properly ff the line is too long.
Single Line Installation
Go To Step 8 for Membrane Line Installation
6. Take approximately 20 feet (6.1 m) of new trimming
line, loop it into two equal lengths. Insert each end of
the line through one of the two holes in the inner reel
(Fig. 17). Pull the line through the inner reel so that
the loop is as small as possible.
I
7. Wind the lines in tight even layers, onto the reel
(Fig. 17). Wind the line in the direction indicated on
the inner reel. Place your index finger between the
two lines to stop the lines from overlapping. Do not
overlap the ends of the line. Proceed to step 11.