Add Engine Oil And Fuel; Attach Bolts To Handle; Attach Accessory Tray To Handle - Troy-Bilt 020242-4 Operator's Manual

Section 3: Assembly
2. Insert carriage boHt through Heft side hoHe from outside
of unit and attach a pHastic knob from inside of unit
(viewing from rear of unit).Tighten by hand (Figure 2).
4. PHaceaccessory tray over holies on handHe (viewing
from front of unit). Push the tree chips into the holies
untiH they sit fiat against the accessory tray (Figure 3).
3.
Insert"L" boHtsthrough holieson right side of handHe
(viewing from rear of unit). HoHdboHtsin pHace and
attach pHastic knobs from inside of handHe(Figure 2).
Tighten by hand.
j_,/"
Acid Engine Oil and Fuel
* PHace pressure washer on a level surface.
° Refer to engine operator's manuaH and follow oiH and fuel
recommendations and instructions.
• Refer _:o engine manual for oil and fuel fill information.
• Damage to equipment resuh:ing from failure _:ofollow this
instrud:ion will void warrant:y,
NOTE_ Check oiH often during engine break-in. Refer to
engine operator's manual for recommendations,
0