Connect Hose And Water Supply To Pump; Connect High Pressure Hose To Pump; Connect Garden Hose To Water Inlet; Checklist Before Starting Engine - Troy-Bilt 020242-4 Operator's Manual

Section 3: Assembly
Connect Hose and Water Supply to
mMPORTANT:To avoid pump damage,you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I. Attach one end of high pressure hose to high pressure
outlet on pump (Figure 4).Tighten by hand.
2. Attach other end of hose to base of spray gun
(Figure 5).Tighten by hand.
4. Run water through garden hose for 30 seconds to
clean out any debris.Turn off water.
mMPORTANT: DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 6).
• Damage to equipment resulting from failure to follow this
instruction will void warrantT;
6. Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection,
3.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains
debris, replace if damaged. DO NOT RUN PRESSURE
WASHEP, IF SCREEN IS DAHAGED.
Checklist Before Starting Engine
Review the unit's assembly to confirm you have performed
all of the following:
I. Hake sure handle is in place and secure.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Ched< for properly attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
Pressure_A/asher"before using pressure washer.