Add Engine Oil And Fuel - Troy-Bilt 1902 Owner's Manual

Figure 3 — Attach "L" Hooks to Handle
Hose Hook
4. Insert other "L" hook through hole just above billboard
on right side of handle (viewing from rear of unit).
Hold hook in place with a pliers and attach locknut
with a 7/16" wrench (Figure 3).

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
Spray Gun
before you start the engine.
Hook
1. Attach one end of high pressure hose to high pressure
outlet on pump (Figure 4).Tighten by hand.
Figure 4 — Connect High Pressure Hose to Water Outlet
2. Attach other end of hose to base of spray gun
(Figure 5).Tighten by hand.
Figure 5 — Connect High Pressure Hose to Spray Gun
7
Section 3: Assembly
Connect High
Pressure Hose
Here