Add Engine Oil And Fuel - Troy-Bilt 20207 Owner's Manual

Figure 3 — Attach "L" Hooks to Handle
Hose Hook
NOTE: If plastic knobs are provided in place of locknuts,
hold hooks in place and attach plastic knobs from inside of
unit.Tighten by hand.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
Spray Gun
the nozzle extension to the spray gun and attach all hoses
Hook
before you start the engine.
1. Attach one end of high pressure hose to high pressure
outlet on pump (Figure 4).Tighten by hand.
Figure 4 — Connect High Pressure Hose to Water Outlet
2. Attach other end of hose to base of spray gun
(Figure 5).Tighten by hand.
Figure 5 — Connect High Pressure Hose to Spray Gun
7
Section 3: Assembly
Connect High
Pressure Hose
Here