Attach Handle; Add Engine Oil And Fuel - Troy-Bilt 20210 Owner's Manual

Section 3: Assembly
Attach Handle
H. PHace handHe assembHy onto handHe supports connected
to main unit. Hake sure holies in handHe aHign with holies
on handHe supports (Figure 2).
HandHe
[[ Supports [
NOTE: It may be necessary to move the handHe supports
from side to side in order to aHign the handHe so it wiHHsHide
over the handHe supports.
2. Insert carriage boHts through holies from outside of unit
and attach pHastic knob on inside of handHes (Figure 3).
Tighten by hand.
i i
3. Insert muHti-coHored spray tips in spaces provided in
handHe.
Add Engine Oil and Fuel
° PHace pressure washer
on a HeveH surface.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty,
o Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oiH often during engine break-in. Refer to
engine owner's manual for recommendations.
Connect
Hose and Water Supply
to
IMPORTANT:To avoid pump damage,you must assembHe
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
H. UncoiH
high
pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). PuHH down
on coHHar of quick connect, sHide onto spray gun and Het
go of coHHar.Tug on hose to be sure of tight connection.
Connect high
pressure hose
here.
NOTE: Remove and discard aHH p ump shipping caps before
attaching hoses.
O