Advertisement
Available languages
Available languages
Section 3: Assembly
BEFORE
STARTmNG THE
ENGmNE
Add
Engine
Oil
° Place
generator
on a [eve[ surface.
l
• Refer to engine operator's
manual for oil fill information.
• Damage
to equipment
resulting
from
failure to follow this
instruction
will void warranty.
° Refer
to engine
operator's
manual
and follow
oil
recommendations
and instructions.
NOTE:
Check
oiH often
during
engine
break-in.
Refer
to
engine
operator's
manual
for recommendations.
NOTE:
The
generator
assembly
rotates
on a prehbricated
and
sealed
ball bearing
that
requires
no additional
lubrication
for the
life of the
bearing.
Add
Fuel
NOTE:
This
gasoline
engine
is certified
to operate
on
gasoline.
Exhaust
Emission
Control
System:
EP1 (Engine
Hodifications).
WARNING
WHEN
ADDING
FUEL
Turn generator
OFF and let it cool at least 2 minutes
before
removing
fuel cap. Loosen
cap slowly to relieve
pressure
in
tank.
Fill fuel tank outdoors.
DO NOT
overfil[ tank_Allow
space for fuel expansion_
Keep fuel away from
sparks, open
flames, pilot lights, heat, and
other
ignition sources.
DO NOT
light a cigarette
or smoke.
I.
Use clean, fresh, regular UNLEADED
gasoline with a
minimum
of 85 octane.
DO NOT use fuel which
contains
Hethanol.
DO NOT
mix oil with fuel.
2.
Clean area around
fuel fill cap, remove
cap.
3.
Slowly add regular unleaded
fuel to fuel tank. Be careful
not to overfill.Allow
about
1.5" of tank space for fuel
expansion
(Figure 3).
Fuel
_N_N_N_NNNNN_
4.
Install fuel cap and wipe up any spilled fuel.
O
Advertisement
