Advertisement
Available languages
Available languages
ASSEMBLY
Your generator
requires some assembHy and is ready for
use after it has been properHy serviced with the
recommended
oiH and fuel
If you have any problems with the assembHyof your
generaton pHeasecaHH t he generator heHpHine at
[-888-6 [ [ -6708. If caHHing f or assistance_pHeasehave the
model revision, and serial number from the data tag available.
See "Know Your Generator"
for data tag location.
Unpack
the Generator
[.
Set the carton on a rigid flat surface.
Z
Open carton compHeteHyby cutting each corner from
top to bottom.
3.
Remove everything from carton except generator.
4.
Leave generator
on carton to instaHH wheeH kit.
Carton
Contents
Check aHH contents against those Histed bellow:
o Hain unit
o Engine oiH
o Operator's
manuaH
o Engine operator's
manuaH
o Battery float charger
° WheeH kit
[f any parts are missing or damaged_ ca[[ the generator
heHpHine at 1-888-611-6708.
Install
Wheel
Kit
The wheeH Halt[s designed to greatly improve the portability
of your generator.
NOTE:
WheeH kit is not intended for overothe-road
use.
You wiHHneed the following
tooHs to instaHH this wheeH kit:
o I/2" or H3mm socket wrench
o H/2" or H3mm open end wrench
o PHiers
° Safety gHasses
Refer to Figure
[ and install
the wheel
kitas follows:
H. TIp generator
so that engine end is up.
2.
SHide axHe through
both mounting
brad<ets.
3.
SHide a whee[
over the axHe.
NOTE
t Be sure to install both wheeHs with the air
pressure
valve on the outboard
side.
WheeH
Axle
20 mm Cap Screw
EoRing
0
Advertisement
