Speed Control Lever; Parking Brake; Decklift Lever - Troy-Bilt Pony Operator's Manual

SpeedControlLever
The speed control lever, located on the left side of
the tractor's dash console, allows you to regulate
the ground speed of the lawn tractor.
To use, depress the clutch-brake pedal and move
the lever out of the parking brake notch and
forward to increase the tractor's ground speed.
When a desired speed has been reached, release
the lever into an appropriate notch to maintain
that speed.
To slow the tractor's ground speed, depress the
clutch-brake pedal and move the speed control
lever rearward and release it into a notch.
ParkingBrake
To set the parking brake, fully depress the clutch- (_
brake pedal. Move the speed control lever all the PAnK
way down and into the parking brake position.
Release the clutch-brake pedal to allow the parking
brake to engage.
To release the parking brake, depress the clutch-brake pedal and
move the speed control lever out of the parking brake position
into the desired position. Release the clutch-brake pedal.
NOTE:The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
DeckLift Lever
Found on your tractor's right fender, the deck lift lever
is used to change the height of the cutting deck. To
use, move the lever to the left, then place in the notch
best suited for your application.
PTO(BladeEngage)Lever
Found on the tractor's right fender, the PTO (blade
engage) lever is used to engage power to the cutting
deck. To operate, move the lever all the way forward.
Moving the lever all the way rearward into the PTO
OFF position disengages power to the cutting deck.
NOTE:The PTO (blade engage) lever must be in the
disengaged (PTO OFF) position when starting the
engine.
ool
z
,U,
m k
o
w
m
z
mZl
M -
&*
12
SECTION 4--
CONTROLS
& FEATURES