Throttle Control Lever; Choke Control; Brake Pedal - Troy-Bilt Super Bronco 60TG Operator's Manual

Throttle Control Lever

The throttle control lever is located on the right side of
the tractor's dash panel. This lever controls the speed
of the engine and when pushed all the way forward, the
choke control also. When set in a given position, the
throttle will maintain a uniform engine speed. See Figure
6.
IMPORTANT: When operating the tractor with the cutting
deck engaged, be certain that the throttle lever is always
in the FAST (rabbit) position.

Choke Control

Moving the throttle lever all the way
forward activates the engine's choke
control. Activating the choke control
closes the choke plate on the carbu-
retor and aids in starting the engine.
Refer to Starting The Engine in this
section of the manual for detailed
starting instructions.

Brake Pedal

The brake pedal is located on the
right front side of the tractor above
the drive pedal along the running
board. The brake pedal can be
used for sudden stops or setting the
parking brake.
NOTE: The brake pedal must be
fully depressed to activate the safety
interlock switch when starting the
tractor.
Ignition Switch Module
WARNING: Never leave a running
machine unattended. Always
disengage PTO, move shift lever
into neutral position, set parking
brake, stop engine and remove
key to prevent unintended
starting.
To start the engine, insert the key into the ignition switch
and turn clockwise to the START position. Release the
key into the NORMAL MOWING MODE position once
the engine has fired.
To stop the engine, turn the ignition key counterclockwise
to the OFF position. See Figure 7.
�����
��������
����
��������
����
��������
Figure 6
����
��������
Figure 7
IMPORTANT: Prior to operating the tractor, refer to both
Safety Interlock Switches and Starting The Engine
in this section of the manual for detailed instructions
regarding the Ignition Switch Module and operating the
tractor in REVERSE CAUTION MODE.
Drive Pedal
The drive pedal is located below the
brake pedal on the right front side of
the tractor along the running board.
Depress the drive pedal with your
right foot when the tractor shift lever
is in either FORWARD or REVERSE
to cause the tractor to move. Ground
speed is also controlled with the drive
pedal. The further down the pedal is
depressed, the faster the tractor will travel. The pedal will
return to its original position when it's not depressed.
IMPORTANT: Always set the parking brake when leaving
the tractor unattended.
11
4
Operating
Your Lawn
Tractor
WARNING
������
������ ����
Never leave a running
machine unattended.
�����
Always disengage
��������
PTO, move shift lever
into neutral position,
set parking brake, stop
engine and remove key
to prevent unintended
starting.
IMPORTANT
Prior to operating the
tractor, refer to both
Safety Interlock
Switches and Starting
The Engine in this
section of the manual
for detailed instructions
regarding the Ignition
Switch Module and
operating the tractor in
REVERSE CAUTION
MODE.