Samsung Esa PDP4294LV Owner's Instructions Manual page 29

1
First, select the correct signal source (Ant, STD, HRC,
IRC}. See steps on previous page.
Press the Menu button. Move the joystick up or down to
select "Channel", then press the joystick to enter.
< An_
Auto Program
Fine Tune 4 O
LNA 4 Off P.
Ch Scan
3
Move the joystick up or down to select "Auto Program",
then press the joystick to enter.
The PDPwill begin memorizing all of the available
channels.
After all the available channels are stored, the
Auto program menu reappears. Move the joystick right
to exit.
Ant / CAW { Ant _"
Fine Tune _ 0 J,
LNA 4 Off 1,
Ch Scan
..... ; Move ] Enter i) Menu
Ant s0
Auto Program
: Stop
" The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to _'o minutes.
29