Storage - Remington 104316-01 Owner's Manual

CLEANING AND
MAINTENANCE
Continued
9. Gently push on sharpener knob. Saw must be running for chain m sharpen.
Note: Sparks appearing shows sharpener is working (see Figure 25). If no sparks
appear, continue to adjust sharpener one click at a time. After each click, press
sharpener knob until light flow of sparks appears.
\
STORAGE
Figure 25 - Sharpening Fast Sharp Chain
After several sharpenings, you must turn sharpener knob more to bring stone into
position•
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use
replacement chain noted in this manual. Always include new drive sprocket when
replacing chain. This will maintain proper driving of chain. Note: For proper chain
and drive sprocket, see Replacement Parts and Accessories, page 28.
If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean guide bar and chain by soaking in
petroleum based solvent or mild soup and water mixture.
3. Dry guide ba[ and chain:
4. Place chain in container filled with oil. This will prevent rust.
5. Wipe a thin coating of oil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth dampened with a mild
soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children's reach
• in a dry place
• in a ca'Tying case or with scabbard over guide bar