Table of Contents
Advertisement
HOWTOINSTALL THERECEIVER FORTHEOPTIONAL C HEST PULSE SENSOR
If you purchasethe optionalchest pulsesensor(seepage19),follow thestepsbelowto
install the receiver
included with the chest pulse sensor.
1. Refer to assembly step 4 on page 5, and remove the
two M4 x 25mm Screws (not shown) and the Bookrack
(55).
Next, look under the console and locate the three indi-
cated screws (not shown). Remove the three screws.
Do not remove the screws attaching
the Console to
the Handlebar
Post (6).
2. Carefully lift the top of the Console (9) as shown. Using
the two small screws included with the chest pulse sen=
sot, attach the receiver to the indicated plastic posts on
the Console. Make sure that the receiver
is turned
exactly as shown.
Connect the wire on the receiver to
the indicated wire on the Console.
Refer to step 1 above. Lower the top of the Console (9).
Make sure that no wires are pinched.
Reattach the
top of the Console with the three screws removed in
step 1. Refer to assembly step 4 on page 5, and teat=
tach the Bookrack (55) with the two M4 x 25mm
Screws (not shown). Note: The remaining wires includ=
ed with the chest pulse sensor may be discarded.
55
Screws
._j9
L
s Posts
HOW TO ADJUST THE POSmON
OF THE SEAT
For effective exercise, the seat should be in the proper
position. As you pedal, there should be a slight bend
in your knees when the pedals are in the farthest
position. To adjust
the seat, pull the
seat knob and
slide the seat car=
Seat
riage to the desired
position. Release
the seat knob and
slide the seat car-
riage back and
forth slightly
until
Seat
it locks into posi=
Knob
tion.
r
HOW TO ADJUST THE PEDAL STRAPS
To adjust the pedal
straps, first pull the
ends of the straps
off the tabs on the
pedals. Adjust the
straps to the
desired positions
and press the ends
of the straps back
onto the tabs.
,Strap
Advertisement
Table of Contents
