Table of Contents
Advertisement
9. AttachtheBackrest (13)to theSeatCarriage (11)
withfour1/4"x 38mmHexScrews (78)andfour M6
Washers (25).
10.PulltheseatknobandslidetheSeatCarriage (11)
ontotheSeatRail(7).
Refertotheinsetdrawing. H oldtheBumper A xle
(82)inside of theSeatRail(7).Attachthetwo
Bumpers ( 84)to theendsof theBumper A xlewith
two M6x 16mm Button Screws (85)andtwoM6
Washers (25)asshown. P ress theSeatRaiJ
Endcap (23)intotheendoftheSeatRail.
11.Firmly tightenthefourM8x 31mmButton Screws
(80)intheSeatCarriage (11).Note:Therearetwo
Button Screws in eachside.
PulltheseatknobandslidetheSeatCarriage (11)
to thedesired position. Release theseatknoband
slide the SeatCarriage backandforth slightly
until
it locks into position,
Make sure to regularly
tighten
the four M8 x 31ram Button Screws (80}.
12. identify the Right Pedal (37), which is marked with
an "R." Using an adjustable wrench, firmly tighten
the Right Pedal clockwise into the Right Crank Arm
(65). Tighten the Left Pedal (not shown) counter=
clockwise into the Left Crank Arm (not shown).
After using the exercise
cycle for one week,
retighten the Pedals.
Attach the Right Pedal Strap (38) to the Right Pedal
(37), and press the end of the Right Pedal Strap
onto the tab on the Right Pedal. Attach the Left
Pedal Strap (not shown) in the same way
78
10
11
12
25
11/
Knob
11
11
13
85
8O
,
Knob
,l
,,,'
i,,
,_
/
//
/
65
38
/
13. Make sure that all parts are properly
tightened
before you use the exercise
cycle. Place a mat
beneath
the exercise
cycle to protect
the floor.
Advertisement
Table of Contents
