Table of Contents
Advertisement
Things
to Consider
Before
You Connect
Protect Against
Power Surges
,,
Connect all dcvic'es b_'fore you p]ug any of th_'ir pow¢,r cords into th<' wall outk't or pow_,r
strip. NEVER p]ug your TV into an outlet that is control]ed by a wal] switch.
,,
Turn <)ftthe T\i and/or device(s) before you connect or disconnect
any canes.
,,
Make sure all antennas
and canes are properly
grounded.
Re_br to the Important
Saf_'ty
Instructions
at the beginning
of the User's Guide.
Protect Devices from Overheating
',
I)on't block ventilation
holes on any of the clcvic'cs. Arrange, the dcviccs so that air can
circulate freely.
,,
I)on't stack devices.
,,
If you place devices in a stand, make sure you allow adequate
ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf so the heate(I air
from it won't flow around other devices.
Position
Cables Property
to Avoid
Audio
interference
•
Insert each c'ab]c firmly into the designated
jack.
,,
If you place devices above the T\", route all cables down the side of the back of the T\"
instead of straight down the middle.
•
If your antenna
uses 300-ohm twin lead canes,
do not coil the canes.
Also, keep the twin
lead cables away from audio/video
cables.
Use indirect
Light
Don't p]acc the TV where sun]ight or room lighting wJl] be directed towald the screen. Use so_t
or indirect lighting.
Check Supplied
Parts
Check that the following palts were packed witll yore product.
Remote control
Part # R130A1
2 AA batteries
Power cord
#'hapter_
Gr(#)bics
conl_zin_'d
u,ilbin
lbis pz/blicalion
ar_</'or
r(>!)r_>x_nl_zlion
on!)<
1665105Bindb
5
4_
2/I7/06
6:31:39PM
Advertisement
Table of Contents
