Chapter 1: Connections & Setup; Things To Consider Before You Connect; Protect Against Power Surges; Instructions At The Beginning Of The User's Guide - RCA L26WD21 User Manual

Rca lcd tv user's guide
Table of Contents

Advertisement

Things to Consider Before You Connect

Protect Against Power Surges

Connect all devices before you plug any of their power cords into the wall outlet or power
strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
Turn off the TV and/or device(s) before you connect or disconnect any cables.
Make sure all antennas and cables are properly grounded. Refer to the Important Safety.

Instructions at the beginning of the User's Guide

Protect Devices from Overheating.
Don't block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
Don't stack devices.
If you place devices in a stand, make sure you allow adequate ventilation.
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
from it won't flow around other devices.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.
If you place devices above the TV, route all cables down the side of the back of the TV
instead of straight down the middle.
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.

Use Indirect Light

Don't place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.

Check Supplied Parts

Check that the following parts were packed with your product.
POWER
MUTE
1
2
3
4
5
6
7
8
9
0
SUB CH
GO BACK
CH
VOL
VOL
CH
MENU
CLEAR
OK
INFO
CC
SOUND
ZOOM-
ZOOM+
PICTURE
SLEEP
GUIDE
PRESETS
2 AAA batteries
Remote control
Note: If you need to replace your remote, call 1-800-338-0376. A shipping and handling
fee, and the appropriate sales tax, will be charged upon ordering. Have your Visa,
MasterCard, or Discover Card ready.
Chapter 1
Graphics contained within this publication are for representation only.
Chapter 1: Connections and Setup
Power cord
two (2) table stand feet
four (4) M5 x 16 screws
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents